![]() Ip local pool Scott_VPN_Pool 10.6.31.245-10.6.31.245 mask 255.255.255.0Ĭrypto dynamic-map Statham 1 set transform-set esp-sha-hmacĬrypto dynamic-map Statham 1 set reverse routeĬrypto map Stathammap 1 ipsec-isakmp dynamic StathamĪccess-list inside_nat0_outbound extended permit ip any 10.6.31.245 255.255.255.255Īccess-list SPLIT_DNS extended permit ip 10.0.0.0 255.0.0. VPN works but still unable to reach devices in the inside. The remote sites connects via a lan-to-lan VPN on the outside. The ASAs routing table has an entry for DeeperNet. For step-by-step instructions to build the Azure configurations, see Single VPN tunnel setup. You can optionally configure the BGP across the VPN tunnel. On the inside there are two subnets, InsideNet and DeeperNet, connected by a simple router. This configuration consists of a single S2S VPN tunnel between an Azure VPN gateway and an on-premises VPN device. Before getting into the configuration details of Cisco ASA backup scheme (called failover), I would like to point out a few rules regarding the technology itself: Of the two Cisco ASA devices that have been combined into a cluster and configured to work in the failover mode, only one () device will be active and forward traffic. ![]() Thanks for the link, i have prepared the configuration based on what i study from the link and from few other sites can you please let me know if this will work I have a Cisco ASA 5510 with three interfaces.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |